Ripped Jeans Ideas description

How to Make Jin Torn Torn
You can tear yourself easily jin. On the right foot. materials, and patience, you can tear jin easily and quickly.
Step
Choose jeans that fit your body size. You can rip any jeans and get the same result, but you do not have to tear the jeans that you have, because you can make savings by buying a used genie cheap and comfortable in a thrift store or used clothing.
Using the genie that has been used can give better results than the new genie, but that does not mean you should not buy new pants for this project.
Jin colored light to medium usually gives a good result if torn, because the color to give a more "chaotic". Jin dark will seem like just dipped into the dye so it might look "realistic" if torn.
Gather the ingredients. All you need to rip your genie is a jeans and something sharp. However, depending on the type of style you want, you may want to use sharp tools appropriate for the job:
If you want to make a big hole, use scissors, razor or a sharp knife to rip jin.
To create the look outdated, use abrasives, grated cheese, steel wool, or pumice.
Decide where you want to rip. Expand your genie on the table, and use a pencil to mark where you want to rip. Use a ruler to mark the length you want. Imagine the final shape and length and width of the hole you want.
Typically, most people just rip in the knee area, although you can snag anywhere around the trouser leg.
Try and aim a little higher than your knees, so tattered pieces will not grow large when you walk. Every time you bend the knee, pit will be caught in the knee and enlarge the tattered pieces.
Do not make the tear is too high, because your underwear can be seen.
4. Expand jeans on a flat surface. Slip a small piece of wood to put in the trouser leg when you create a worn, so that you do not change the front and rear as well. [1]
Or, you could even use a cutting board, old books or stacks of magazines, or anything that you no longer use. But do not do it on the kitchen table, if you use a very sharp knife.
5. Start building your genie tufted using sandpaper. Before you start chopping jin, use sandpaper or steel wool to scrub and attenuate the point you want to rip. This helps loosen the fibers within jin and make it more easily torn.
Use a wide variety of different tools. Use sandpaper, steel wool, and pumice alternately if you have it. Ripping jin will probably spend a lot of time, depending on the thickness of your genie.
If you prefer to cut jin, go ahead. You do not need to be loosened in advance, unless you want your hole tufted look.
6. Loosen the fiber to create the hole. If you want to make a tufted area and fillings lint in your genie, use scissors or knife to pull the threads in the area that you just created becomes obsolete. This will loosen the fibers in that area, which will reveal a little skin when worn. Pull all white thread sticking out of the genie to give the impression of style.
7. Add the hole with a knife or scissors. Grab your scissors and cut out a small section in the area that you create becomes obsolete. Make a hole as small as possible. You can just make it bigger, but you risk damaging the genie and make it unusable if the hole is too big. Do not make the hole more than 1.5 cm.
Make tear on your whole body, not just up and down. It looks more natural.
Use your hands to rip jin deeper. Tear off will decide the fiber, so it will look like a real hole. Pull the thread a little bit out, so tattered pieces looks natural.
Do not make too many holes, because it will produce a piece of fabric edge is very neat and unnatural.
Alternatively, you can also cut a small hole and let the hole was growing, when you put the genie. This way it will look more natural.